Change a Propane Tank
Propane fueled forklifts are normally utilized in warehouses. The forklift is designed with the propane tank mounted at the back of the driver. The tanks, that look much like beer kegs, need to be replaced every so often because they have a limited lifespan. Forklift drivers should always use caution when handling propane tanks. Compressed gases are really dangerous, especially since the gas is flammable. Always use care when replacing and removing propane tank to avoid injury.
1 To change a propane tank, first stop the forklift and leave the engine running, and turn the valve on the tank off. Let the forklift run until the engine dies. This process burns the gas off in the transfer hose which connects the engine and the tank. Before taking the second steps, wear the correct safety equipment, such as insulated gloves made of either neoprene or leather. It is really essential for you to protect your skin from touching the compressed gas, that is very cold.
2 Disconnect the hose from the tank and take off the holding straps to remove the tank. When putting in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 You could check for leaks by applying soapy water to the valve and opening it slightly. Leaking gas would cause bubbles to foam around the value. If this happens, check the connection hose at the nut and the valve area. Re-tighten the connecting nut if you detect any leaks around the valve area, and afterward perform the leak checking procedure once more. Persistent leaks mean that the nut and connecting hose must be replaced. However, if replacing the nut and hose still does not stop the leak, the tank would have to be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. Afterward you could start the forklift and continue operating.